Electric motors drive the pumps, fans, compressors, conveyors and machine tools that keep plants and buildings running, and in the UAE’s heat and dust they work hard. When a motor trips, overheats or burns out, a professional rewind can usually return it to service faster and at lower cost than sourcing a replacement — especially for large or non-standard motors.
Global Prime Engineering rewinds AC and DC motors at our workshop in Sharjah Industrial Area 2, alongside generator winding and compressor repair. Because we are also a full machine shop, mechanical problems such as worn shafts and bearing housings can be fixed in the same place.

Why motor windings fail
- Overloading and overheating, from a jammed load, blocked ventilation or high ambient temperatures
- Single-phasing or voltage imbalance on three-phase supplies
- Moisture, dust and contamination breaking down the insulation
- Bearing failure that lets the rotor rub against the stator
- Frequent starts and stops beyond what the motor is rated for
- Age: insulation gradually degrades after years of heating and cooling
Signs your motor needs attention
- A burning smell or visible smoke
- The breaker or overload relay tripping repeatedly
- The motor running hot, humming or failing to start
- Unusual noise or vibration, often from worn bearings
- Falling insulation resistance readings during routine maintenance
Don’t keep resetting the trip
Repeated tripping is a warning. Restarting a motor with a developing winding fault can turn a repairable problem into a burnt-out stator and a damaged core.
How a professional motor rewind works
- 1
Inspection and testing
The motor is inspected and the windings tested to confirm the fault and check for mechanical damage.
- 2
Recording the winding data
Before stripping, the original winding details — turns, coil pitch, wire size and connections — are recorded so that the new winding matches the motor’s design.
- 3
Stripping and core cleaning
The old windings and insulation are removed, and the stator core is cleaned and checked.
- 4
Rewinding
New coils are wound with the correct copper wire and fresh slot insulation, then connected to match the original design.
- 5
Varnishing and curing
The winding is impregnated with insulating varnish and cured to bond the coils and protect them against moisture and vibration.
- 6
Mechanical repairs
Bearings are replaced, and worn shafts or bearing housings are repaired on our lathes when needed.
- 7
Final testing
The motor is tested before it is returned to you.
Motors and machines we handle
- Three-phase and single-phase AC induction motors
- DC motors
- Generators and alternators
- Compressor motors
- Pump, fan and blower motors
- Motors for machine tools, conveyors and production lines
Rewind or replace?
Rewinding is usually the better choice for larger motors, for older or special-purpose motors where an exact replacement is hard to find, and for motors whose mounting or shaft arrangement is built into your machine. For small, standard motors, a new unit can sometimes cost about the same.
A careful rewind that matches the original winding data helps preserve the motor’s performance. After inspection, we give you an honest recommendation either way.
Frequently asked questions
How long does motor rewinding take?
It depends on the motor’s size and type, the availability of materials and our workload. We confirm a timeline after inspecting the motor.
Is rewinding cheaper than buying a new motor?
For medium and large motors, rewinding is usually more economical than replacement. For small standard motors the difference can be smaller, and we will tell you if a new motor makes more sense.
Do you rewind DC motors as well as AC motors?
Yes. We rewind AC and DC motors, as well as generators and compressor motors.
Can you repair the bearings and shaft at the same time?
Yes. Because we are also a machine shop, we replace bearings and repair worn shafts or bearing housings as part of the same job.
Do you serve customers in Dubai and Ajman?
Yes. Our workshop in Industrial Area 2, Sharjah is a short drive from Dubai and Ajman, and we work with customers across the UAE.